Dear Sir,
I have RESP file and polezero file which produced from SEED volumes by the RDSEED
program.
I want to remove the instrument response from "file.SAC" and apply the the polezero file that I create.
if I apply the command "trans from evalresp to polezero subtype "created filename" freq 0.025 0.05 10 20" is it correct command and makes sense?
Should I do a taper command when I apply transfer? If I don't do it, what's the effect on my signal?
Thank You
Regards,
Ami
I have RESP file and polezero file which produced from SEED volumes by the RDSEED
program.
I want to remove the instrument response from "file.SAC" and apply the the polezero file that I create.
if I apply the command "trans from evalresp to polezero subtype "created filename" freq 0.025 0.05 10 20" is it correct command and makes sense?
Should I do a taper command when I apply transfer? If I don't do it, what's the effect on my signal?
Thank You
Regards,
Ami
-
On 10/29/2014 03:16 PM, amik Amik wrote:
Dear Sir,
As far as I can see, your command is correct.
I have RESP file and polezero file which produced from SEED volumes by the RDSEED program.
I want to remove the instrument response from "file.SAC" and apply the the polezero file that I create.
if I apply the command "trans from evalresp to polezero subtype "created filename" freq 0.025 0.05 10 20" is it correct command and makes sense?
Should I do a taper command when I apply transfer? If I don't do it, what's the effect on my signal?
Thank You
Regards,
Ami
_______________________________________________
sac-help mailing list
sac-help<at>iris.washington.edu
http://www.iris.washington.edu/mailman/listinfo/sac-help
I normally apply "rmean", "rtrend" and "taper" before any
filtering operation including deconvolution. Otherwise
the sharp cutoffs at the ends of your trace may cause large
artificial signals when the filter is applied.
Regards,
Sheila Peacock.